Case Studies

Manufacturer Reduces Board Failure Rate to 0.2%
March 16, 2020

After repeated attempts to solve exposed circuit board failure rate of 20%, a manufacturer turned to Appli-Tec for help.

Appli-Tec Custom Material Development Case Study: Contractor Replaces Discontinued Raw Material
February 26, 2020

Appli-Tec helps minimize delay and costs by finding a substitute material.

Layers in an ultrasound probe The Use of Specialty Materials in Ultrasound Probes
October 24, 2019

How Appli-Tec uses adhesives to create materials used in specialty applications, such as ultrasound probes.

thermally-conductive-adheives Case Study: Appli-Thane 7300 Solves Circuit Board Heat Challenge
February 11, 2016

An engineer turned to Appli-Tec for an adhesive compound with high thermal conductivity and a 4-hour pot life.

Appli-Tec Fabricates Sensor that Integrates Adhesive
October 12, 2015

Appli-Tec fabricated a sensor that integrated six parts plus an adhesive Appli-Tec mixed in-house. Sensors arrived at the factory, ready for installation.

Appli-Tec Creates Reusable Molds
October 12, 2015

Appli-Tec helps a company create resuable molds by mixing, dispensing and curing a silicone material to conform to an intricate metal mold.

appli-tec-urethane-adhesive Medical Device Company Turns to PMF Adhesives
August 26, 2015

A medical device manufacturer eliminated in-house mixing by purchasing PMF adhesives from Appli-Tec.

Contractor Eliminates Meter Mix Machine
August 26, 2015

A process engineer called on Appli-Tec to help the company reduce labor and adhesive mixing costs.

Manufacturer Saves Costs; Eliminates In-House Mixing
August 26, 2015

Replacing the mixing machine was quite costly, so a manufacturer turned to PMF adhesives from Appli-Tec.