Appli-Thane® 7810

0.25 W/mK

The free-flowing version of our 7800 material, Appli-Thane 7810 is ideal for coating applications. Both 7810 and 7800 are often used together for “dam and fill”: use the higher viscosity 7800 to create the dam, then 7810 to fill in. Appli-Thane 7810 features good flow and wetting, is easily reworkable, and meets NASA’s low outgassing requirements.


Work Life @ 25°C1.5 hours
Viscosity @ 25°C6,400 cPs
Thixotropic Index1.0
Shelf Life6 Months @ -40°C 9 Months @ -60°C

Cure Options

2.5 hours @ 66°C 72 hours @ 25°C

Cured Properties

Based on cure of 2.5 hours @ 66°C

Shore A Hardness65
Glass Transition Temp (°C)-74
Density (g/cc)0.96
Lap Shear 2024T3 Clad (psi)400
Tensile Modulus (psi)735
Elongation (%)50
Tensile Strength at Break (psi)240
Fungus ResistanceNon-nutrient

Electrical Properties

Based on cure of 2.5 hours @ 66°C

Dielectric Constant2.85 @ 1 MHz
Dissipation Factor0.05 @ 1 MHz
Dielectric Strength (volts/mil)1,120
Volume Resistivity (ohm-cm)2.0E 13 @ 500 VDC
Arc Resistance (seconds)123

Thermal Properties

Based on cure of 2.5 hours @ 66°C

CTE below Tg (ppm/°C)80
CTE above Tg (ppm/°C)200
Glass Transition Temp (°C)-74
Operating Temp. Range (°C)-100 to 125
Thermal Conductivity (W/mK)0.25

Outgassing Properties

Based on cure of 2.5 hours @ 66°C

TML (%)0.38
CVCM (%)0.01
WVR (%)0.20

Acoustic Properties

Velocity (m/s)1,600
Impedance (MRayls)1.53
Loss (dB/cm-MHz)-4.8
Density (g/cc)0.96

Key Features

  • Free Flowing
  • Electrically Insulative
  • Flexible
  • Hydrolytic Stability
  • Long Pot Life
  • Low Glass Transition Temperature
  • Low Modulus
  • Meets NASA Outgassing Requirements
  • Solvent Resistant
  • Fungus Resistant

The data contained herein is provided for informational purposes only and are believed to be reliable. APPLI-TEC does not guarantee suitability of this product for any resultant application or freedom from patent infringement. Furthermore, APPLI-TEC disclaims any liability for incidental and consequential damages of any kind including but not limited to lost profits.

Rev I

General Inquiry

I have a technical question, need an SDS, etc.

Email Customer Service

New Applications

I want to discuss my application challenges, order samples, or place a first-time order.

Email a Technical Specialist

Existing Applications

I need to reorder an existing part number, I have a BOM/Spec.

Email Inside Sales